04-28-2005, 04:00 PM
|
|
CC Member
|
|
|
Join Date: Dec 2004
Location: toronto,
ont
Cobra Make, Engine: 408w 500 h.p. 550 ft.lbs
Posts: 562
|
|
Not Ranked
Bob-- Please help
Hi Bob,
I spoke with Peter today after you left work about shipping me a clutch slave cylinder setup.
I supplied my car builder a complete 351/408W set up with a 15-200 Lakewood shield with a top loader (small spline) a Ford #7515-2A fork all set up ready to drop in the car.
Easy right?
He has informed me it is impossible to set up a slave cylinder to operate the clutch. The angle of the dangle does not correspond with the protracted radius of the hoojit!
IDIOT!!!!!!!
As I live several hours away from his shop it is difficult to go there & sort him out, that is why I need your help (sob,sob)
As he is three months behind schedule already I don't need to give him any excuses to hold things up.
Could you possibly send me a photo or two of your setup that I have ordered mounted on a assembly that I could show this @##$%@&*%# IDIOT.
Thanking you in advance for your help,
Regards
Craig
|
Threaded Mode
