11-21-2007, 07:22 PM
|
 |
CC Member
|
|
|
Join Date: Nov 1999
Cobra Make, Engine: ERA 739
Posts: 604
|
|
Not Ranked
I have not done any trimming on the pipes yet. Mainly b/c I had ERA mount the tabs and coat the pipes so at this point in time they are simply bolted on. If I can get this right, that is my next step. I put some pics in my gallary if for some reason I can't figure this out. The net of it - with everything center and level in the car, I can barely get a finger tip in the top and have about 2 fingers from the bottom of pipe to the bottom of the whole. Take a look and let me know if you have any ideas. My only other thought was to find a way to get the motor to sit lower in the saddle as I still have room in the frame mount for the motor to sit lower.
[IMG]  [/IMG]
[IMG]  [/IMG] |
Threaded Mode
