09-10-2001, 10:46 PM
|
|
Senior Club Cobra Member
|
|
|
Join Date: Apr 1999
Location: Hastings, Nebraska USA,
Posts: 345
|
|
Not Ranked
Valve Adjustment
Hi Don....
read it again...it says "Next, turn the engine over until number 1 Intake valve opens completely and almost closes(watch it closely).....that means open completely and then comes back to almost close...and then adjust #1 exhaust valve....
http://www.gessford.com/images/mechrockerhydcam.htm
Hope this helps....
If the new push rod is 9.360 "effective" length that's about .150" longer than a stock adjustable style push rod....not too often do we run into a long push rod with out a good reason....did you check the box the lifters came in yet....Edelbrock part number ____
Regards, george
I only mention this becasue I have received the Edelbrock Performer RPM Camshaft Kits with small block lifters in place of the correct FE lifters...and they are shorter and they would require about a .150 longer push rod....
George |
Threaded Mode
