05-29-2018, 03:47 PM
|
 |
CC Member
|
|
|
Join Date: May 2008
Location: Brisbane,
QLD
Cobra Make, Engine:
Posts: 2,797
|
|
Not Ranked
Quote:
Originally Posted by TexasSnake
I completely agree with your observation of the MSD plug wire performance. I had been running Accel Pro Stock wires on my FE and didn't think that they required replacement. However, I wanted reroute some of the plug wires and elected to use the MSD universal kit that I could cut to the length I required. After making the change you could actually feel the difference in performance which surprised me. I was curious so I cut two identical pieces of the MSD and Excell Pro Stock and tested them for resistance. Don't recall the exact numbers but the MSD wire resistance was a small fraction of the Accel. Highly recommended if you are upgrading your plug wires.
|
Must have had some faulty wires.
I've have run the Accel 150 ohm wires, and the MSD wires.
I doubt whether anybody could tell the difference between 50 and 150 ohms, considering normal stock wires are 3k - 8k ohms per foot.
Gary
Last edited by Gaz64; 05-30-2018 at 12:52 AM..
|
2Likes
Threaded Mode
