Reading Plugs? Calling all FE experts...

[DuckRyder]

Bruce,

If you get the list number off of it (front of Choke housing, will look like 0-4478-11) you can then find the factory set up at: (probably)

http://www.holley.com/HiOctn/ProdLine/CarbList.pdf

If (or once you do from the list number) you know the series, you can find exploded views at:

http://www.holley.com/HiOctn/TechSer...o/FMCTech.html

I'd suggest picking up a book if you are going to get too involved, but checking jet sizes is as easy as pulling the fuel lines and the 4 bolts out of each float bowl and looking at the numbers.

You're Probably going to want to pull the carb to do it, since I've never found a way to keep the fuel from going all over the engine.

The carb may or may not have limited reusable gaskets, and you'll want a base plate gasket on hand too.

I used to have a good website on Holley tuning, but can't find it right now, maybe someone else will pipe in with one.

Edit: Here is the site it might help, but these guys here are probably the best resource for a cobra application.

http://www.bob2000.com/carb.htm