07-23-2005, 10:17 PM
|
|
CC Member
|
|
|
Join Date: Apr 2005
Location: Fareham,
hm
Cobra Make, Engine: dax x 2 one sbf one bbf
Posts: 10
|
|
Not Ranked
ok well it has been a few months and im still looking at a ford 360 with cast heads and inlet manifold does anyone have some bits off of an fe that are surpluss to requirement im after a performer 390 inlet manifold as it is the lowest and i cant fit a hight inlet to my engine as the filter will be sticking out of the hood trust me guys they dont make them out here like you guys do the fact im fitting a ford is bad enough fitting an fe is a sin out here the fact it is not a chevy is frowned upon these brits are a bit backwards well some are so any help getting bits would be apreciated ill let you guy correct my spelling too as it is 05:23 in the monring here ill use that as my excuse for bad spelling thank you once again in advace for you help 
oh yeah it is a 360 still and i have made a u turn any ideas on a bigger crankshaft??? you guys are right 360 just isnt enough i have to do something to show them chevy boys the way
Last edited by pictus; 07-23-2005 at 10:24 PM..
|
Threaded Mode
