
06-18-2005, 08:17 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Jun 2004
Location: Huntington,
VT
Cobra Make, Engine: E-M 427 Top Oiler stroked to 482 by KC, Stage 2 heads, a Quikfuel and Voila, 640 hp
Posts: 502
|
|
Not Ranked
Well, I've ordered an 11" K&N X-stream filter - total height ~ 3.5". The only issue at this point may be clearance with the float adjustment screws fore and aft. I'm thinking about either using a .5" spacer ring if they interfere or drilling two holes, slightly larger than the adjustment screws, in the filter base. I don't think the holes should have much if any impact on air flow dynamics but would welcome any comments.
Thanks
Tim[u]
__________________
At first, nothing happened. Then after a few seconds, nothing continued to happen.
Douglas Adams - Hitchhiker's guide to the Galaxy
|