FE flywheel bolt pattern

1966plus · #1 (**permalink**) 02-14-2008, 05:40 AM

Hi Guys,
another techie question for you.

Does anbody know the correct bolt pattern on an FE flywheel/crank? My flywheel from KEP has 2 holes at a slightly different radius from the other 4, whilst my crank (supplied on a built engine from Huddart Engines in the UK) has all 6 holes at the same distance from the centre. No matter how the flywheel is rotated only 4 holes will line up!

Which of these is correct for the FE?

The flywheel will have to be modified whatever the answer, I would just like to know who has sent the correct spec part?

Barry_R · #2 (**permalink**) 02-14-2008, 06:05 AM

All holes on the same circle. One hole is offset though - the flywheel will only locate in one position. You will spend more time than you think finding the "right" spot...by spinning the wheel on the crank.

1966plus · #3 (**permalink**) 02-14-2008, 06:23 AM

Thanks for that, I knew that if there was an answer to be had then this would be the place to find it.

That helps out hugely

Thanks again

427 S/O · #4 (**permalink**) 02-14-2008, 06:25 AM

Mark it with a punch, just in case it needs removed for whatever reason.



FE Forums sponsored by Keith Craft Inc.