05-31-2007, 01:46 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,944
|
|
Not Ranked
Check the "new" Fel-Pro Printoseal gaskets if you like that particular brand. After I told Fel-Pro about my (and others) failures, they started putting a steel sandwich reinforcement inside to get rid of the short-life-on-the-street problem. I think the new version has a part number ending in "s" or something like that...
I used silicon - on a 460 - and no problems yet.
I used the Victor Reinz - the revised Printoseals weren't out yet.
Here's an earlier thread about this: Intake gasket droop
  
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
Last edited by Tom Wells; 06-01-2007 at 01:25 PM..
|
1Likes
Threaded Mode
