Best Way to set the idle mix on a 4160

patrickt · #1 (**permalink**) 03-18-2018, 05:51 PM

Quote:

Originally Posted by Gaz64

What bush do you have in your distributor to get 21 and 36?

Not MSD. Their black bushing is 18 degrees and that's the smallest one in the kit.

Gaz64 · #2 (**permalink**) 03-18-2018, 05:59 PM

Quote:

Originally Posted by patrickt

Not MSD. Their black bushing is 18 degrees and that's the smallest one in the kit.

Yes, I know 18 is their smallest.

There is a 10 and 14 available on the net, we made a 12.

Gary

patrickt · #3 (**permalink**) 03-18-2018, 06:22 PM

Quote:

Originally Posted by Gaz64

Yes, I know 18 is their smallest.

There ia a 10 and 14 available on the net, we made a 12.

Gary

Trust me, the good doctor ain't milling custom distributor bushings....

steve meltzer · #4 (**permalink**) 03-19-2018, 11:17 AM

OK, thanx for the info about the intake leak, which was immediately obvious after hard driving at the right rear "China" corner, but using a UV light + dye revealed oil leaking from the front, esp on the driver's side and from the rear not only in right corner, but across the middle. I'm just disgusted as I was very careful in trying to do this job. Does anyone ever use the cork gaskets they always supply for the ends? I never have, but jeez...

Timing: I have an MSD box (6 AL, I believe), a standard Ford FE distributor with the advance locked out and an MSD programmable timing computer (8981) now superseded by a the model 8680. s

patrickt · #5 (**permalink**) 03-19-2018, 11:52 AM

Quote:

Originally Posted by steve meltzer

OK, thanx for the info about the intake leak, which was immediately obvious after hard driving at the right rear "China" corner, but using a UV light + dye revealed oil leaking from the front, esp on the driver's side and from the rear not only in right corner, but across the middle. I'm just disgusted as I was very careful in trying to do this job. Does anyone ever use the cork gaskets they always supply for the ends? I never have, but jeez...

I wish I had a "magic bullet" for intake installations to keep them from leaking but, alas, I do not.

If you just can't, can't, can't get it installed without it leaking, and it didn't leak before you removed it, then I would start to suspect something is warped or cracked or the like.

patrickt · #6 (**permalink**) 04-13-2018, 11:54 AM

Well it's time to check in with ol' doc Steve and see if he's making any progress on the Kirkham now that summer time is right around the corner....

steve meltzer · #7 (**permalink**) 04-13-2018, 02:00 PM

oh yessir...I hadn't forgot you either! putting her back together this weekend. intake is on, expansion tank on the workbench, install tomorrow AM, I hope. s