12-02-2010, 11:10 AM
|
 |
CC Member
|
|
|
Join Date: Mar 2001
Location: Provo,
Ut
Cobra Make, Engine: Kirkham, 427
Posts: 6,990
|
|
Not Ranked
2 inch 0.063 wall header tube bends. There is probably enough tubing bends here to make a complete header set for the DIY Cobra builder. There are 39 tubes here. Jegs sells bends for $20 each. That is $780 worth of tube bends. These are prototype bends. Assume the tubes will need to be cut apart and tweaked to make a header and side pipe set. They only have surface rust. Never been used.
$175 takes them all.
There are 11 of these tubes with flanges
There are 28 of these tubes without flanges
Last edited by David Kirkham; 12-02-2010 at 11:16 AM..
|
Threaded Mode
