Kirkham Assembly Manual - Questions Thread...

David Kirkham · #1 (**permalink**) 08-08-2007, 07:24 AM

Busted...

David

JJCobra · #2 (**permalink**) 08-14-2007, 02:44 PM

Hi David- I'm running a Jag rear end and wanted to know if you have to install camber shims on the outboard flanges. Also, what is the current status on the bolt-in stainless headers and sidepipes?

We're dying for more build progress......

Thanks as always.

Jason

David Kirkham · #3 (**permalink**) 08-14-2007, 03:51 PM

Jason,

We do not use the camber shims as we use a plunging upper control arm. We do, however, have to use a spacer to allow the male portion of the 1/2 shaft to mate to the male portion of the axle on the Jaguar units.

Stainless headers are now in production. I have a LOT of customers who want them...so many, in fact, I had to hire a new guy just to work exclusively
on headers.

As for progress on the manual...

I know you are all ready to form a lynch mob and rightly so.

But, maybe, just maybe you will forgive me. I have been a "little" tied up lately with another project. It took 10 years to finally get this project off the ground and everything just finally fell into place. We will be announcing very shortly.

David