CSX2201 and later charging system components

[AndrewB]

They look great!

Working on a new supply of the alternators and possibly a repro of the correct pulley/fan unit!

You would pretty much be my hero. I was resigned to the fact I was going to have to run the smaller pulley version, so I would certainly be in if you were able to repro the fan/pulley setup. I'm getting ready to refurb these guys here soon.


BTW: Notice how the one on the right has a rounded case? Any ideas where that came from?

[Mark IV]

Originally Posted by AndrewB

BTW: Notice how the one on the right has a rounded case? Any ideas where that came from?

The rounded front case is correct. The later "squared-edge" case is from a 65 up unit and will interchange so often found on rebuilts. The rear cases will not interchange as the brush system is different.

We are looking at a correct pulley repop. These would be used on Cobras and 427 Galaxies/Mercury's. Would they sell if the cost $79-99.00? The cost of tooling and the small volume will limit the market and require amortization over a much smaller sales base than say a repop part for a Mustang.

[jolsen42]

If you can do this I am in.

John O