05-04-2017, 10:36 PM
|
 |
CC Member
|
|
|
Join Date: Aug 2009
Location: Adelaide,
SA
Cobra Make, Engine: AP 289FIA 'English' spec.
Posts: 13,152
|
|
Not Ranked
Good suggestions. I'll try my local watchmaker later this afternoon. Thanks Messrs. T & D 
The "monster"? A bit happening there, but not as much as I'd like because of heavy work commitments and some other issues.
I finally found a supplier for correct roll-over bar grommets, so I can finally fit the bar. It has sprung out somewhat so will have to be careful there. Dashboard blank should be ready for pickup early next week. I sourced a correct 30 to 100 degC water temp gauge as well; that's on its way.
I should be putting this on the build thread, not here, shouldn't I?
Cheers,
Glen |
5Likes
Threaded Mode
