New Build

HTM101 · #1 (**permalink**) 07-04-2018, 06:30 AM

Quote:

Originally Posted by Gaz64

Looks really good now.

I'd like to see some heat shielding over the master cylinders.

Craig makes these. It is shipped with a very nice insulating material that is applied to both sides. The insulation wasn't yet installed when this photo was taken.

David

cobrakiwi · #2 (**permalink**) 07-06-2018, 11:10 AM

Here we have one of my oil puke tanks / catch can mounted.
Drilled and tapped the gearbox breather location, made up the fitting to connect the hose to the puke tank.

cobrakiwi · #3 (**permalink**) 07-19-2018, 02:23 PM

Made up the throttle linkage, one of my two piece turkey pans sit on top of the 427.
Getting close to making noise.

cobrakiwi · #4 (**permalink**) 07-19-2018, 02:33 PM

Battery box ready for powder coating, also started in on the transmission tunnel.

indianamoon · #5 (**permalink**) 07-19-2018, 02:37 PM

Shifter length is just about perfect...

1795 · #6 (**permalink**) 07-19-2018, 02:43 PM

Really nice work Craig. I like the use of the heim joints on the throttle linkage. Where do you get the rods and ends for those? I m trying to find some to make straight rod linkages for my top loader.

Jim

cobrakiwi · #7 (**permalink**) 07-19-2018, 03:40 PM

Quote:

Originally Posted by 1795

Really nice work Craig. I like the use of the heim joints on the throttle linkage. Where do you get the rods and ends for those? I m trying to find some to make straight rod linkages for my top loader.

Jim

Jim
Heims from summit or McMaster, I make all the rods to suit.
Cheers.