07-24-2016, 06:20 PM
|
|
CC Member
|
|
|
Join Date: Aug 2010
Location: San Antonio Valley Ca,
ca
Cobra Make, Engine:
Posts: 1,275
|
|
Not Ranked
If your going to MIG tubing and brackets together, the best way I know of is to run hot and fast. Hold med. stick out and carry the heat towards the heavier piece. All being equal, hold to the lower piece on a 60/40 whip motion. If you just drag and lay wire, you'll end up with inconsistent welds, especially as your MIG gun jumps on the drag.
|
574Likes
Hybrid Mode
