03-26-2006, 10:55 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Aug 2004
Location: Near Phila. (Collegeville),
PA
Cobra Make, Engine: CSX2498 has been in our family garage since '68....Scratch built aluminum bodied 427SC Cobra, 427FE, CSX3000 chassis specs, 95% finished, only needs paint.
Posts: 642
|
|
Not Ranked
Progress report:
Thanks, I purchased the footboxes & the CNC firewall from Tim Gunning in AZ. He has an excellent product and he shipped within a week. The CNC firewall was a nice purchase, It helped me locate the front framework. I was not sure just how close I was to prints. The firewall dropped right in.
I did not complete the framework in the trunk area and around the cockpit because I do not have a body yet. I did not want to have to make too many changes to the birdcage when trying to fit the body. So I decided to wait and do both at the same time.
I fabbed the gas pedal assy from scratch. An hour after I finished Mickmate emailed that he has one that I could use as a model. Would of been nice, I made mine from photos on club cobra. Dave, you are welcome to stop by if time permits. I am approx. 30 minutes south of Blandon.
Regards, Karl
|
Threaded Mode
