blue prints

63mercury · #1 (**permalink**) 05-10-2007, 03:39 PM

What ever I do it will be in glass since I don't want the expense of the alum body, and I don't have a wheel nor do I know how to use it. I can do glass work pretty good as I have done a bit of it.The Hurricane boby sounds like a good one but I doubt if they would sell just the body. I'm hoping to make it to the show in Ohio the end of June, I'll inquire there, what's the worst they can say? NO!!!!!!!!!

alfy65 · #2 (**permalink**) 05-11-2007, 04:08 PM

Hey guys,
I started with the Cobra restorer plans, they are a good foundation and change as ya need.

63mercury · #3 (**permalink**) 05-14-2007, 12:42 PM

Patrick, I want to thank you for the present, I put it on CD and took it to the guys I used to work with to see if they could print out larger prints then I can. The print room was down for maintenance today but they said tomorrow is a better day. I am going to look into a body first as was suggested and start gathering materials thru the summer so come snow time in N.E.Mich I will be ready. I am revamping my shop this summer also,not gaining too much more size (96 sq ft) but will be better layout.