02-14-2002, 06:29 AM
|
 |
CC Member
|
|
|
Join Date: Jul 2001
Location: randleman, NC,
Posts: 407
|
|
Not Ranked
Numbers to mull over
OK Draco,
Lets give you some information to chew on. First of all I'm using Dyno 2000 from www.motionsoftware.com. The numbers below are from my engine workup using the items I specified in the previous post.
351 cu in 518 hp@6,000 506lb/ft@4,500
393 cu in 519 hp@5,500 537lb/ft@4,500
408 cu in 520 hp@5,500 549lb/ft@4,000
427 cu in 518 hp@5,500 567lb/ft@4,000
Another deciding factor in going the 393 route was that Speedway motors had a stroker kit for about $1,100 which included h-beam forged rods. The other kits I found were much more expensive. If that 393 won't move a cobra I'll quit! 
Good luck,
h dog
Last edited by hound dog; 02-14-2002 at 06:37 AM..
|
Hybrid Mode
