04-30-2003, 01:02 PM
|
 |
CC Member
|
|
|
Join Date: Jan 2000
Location: Grapevine,
TX
Cobra Make, Engine: Former Owner/Builder of KMP142 427 Sideoiler, Tunnel Wedge, Aluminum heads, etc.
Posts: 702
|
|
Not Ranked
Tom:
There is an MSD adaptor that is usually furnished with the tach, and you need it to do the install. It is a small unit that mounts under your dash. Your tach has three male spade connections, input, output and ground....the adaptor has four - input, output, ignition and ground The MSD module has a recessed spade connector on its side that runs a single wire to the adaptor.
Installation is very straightforward, and if you have purchased the Smiths MSD adaptor, the instructions that come with it are very clear.
Bud  |
Hybrid Mode
