Superformance Harness mounting

justbetter · #1 (**permalink**) 08-03-2004, 05:34 PM

Ok all you Superformance Owners,

I have a 2003 MK3 Superformance here on OZ, and am wanting to mount a 4 point harness.
Now the base points are fine but trying to locate and mount the above sholder locations points are a bit of a problem.

Im not sure if i mount to the roll bar ( or through ) if it is strong enough or crush resistant enough.

Or where there may be other points apart from adding a seperate bar between the two forward roll bars and mount there.

Or if it is safe enough to mount them to the bolt mount that attaches the third rear leg to the forward roll bars, this location seems to high.

Look forward to your help, Pics please.

Regards Garrett

Karl Bebout · #2 (**permalink**) 08-03-2004, 05:43 PM

Garrett, I've always heard that the mounting for the shoulder harness should be lower than the driver's shoulders to be most effective. Enzo, at Finish Line sells a real nice roll bar cross member.

gsharapa · #3 (**permalink**) 08-03-2004, 05:57 PM

If you check from under the car you will see where SPF has slit the fiberglass where you put the belt through and bolt it to the frame cross member behind the seat. The carpet has a small slit in it also but is hard to find. Frame is drilled already!

Randy Rosenberg · #4 (**permalink**) 08-03-2004, 06:38 PM

Gary is 100% right!

Quote:

Originally posted by gsharapa

If you check from under the car you will see where SPF has slit the fiberglass where you put the belt through and bolt it to the frame cross member behind the seat. The carpet has a small slit in it also but is hard to find. Frame is drilled already!