03-07-2005, 04:58 PM
|
 |
CC Member
|
|
|
Join Date: Jan 2002
Location: Northridge,
CA
Cobra Make, Engine: Arntz Cobra
Posts: 1,839
|
|
Not Ranked
Rick,
I had a similar problem, recently. It turned out that the hub shaft was spinning inside the inner race of the bearing. So, the bearing wasn't turning. This made the car feel like I had a flat tire when I was driving it. With the car jacked up, I could push the top and bottom of the tire back and forth about 3/8 of an inch. With my life on the line, I spent the $600 to have it fixed right.
After watching them use big powerful gear pullers and lots of penetrating oil and pounding with big sledge hammers for a long time to remove the bearings. It was money well spent.
Paul
__________________
"It doesn't have anything on it that doesn't make it go faster."
Last edited by RallySnake; 03-07-2005 at 05:01 PM..
|
Threaded Mode
