01-17-2007, 04:00 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Dec 2001
Location: Shasta Lake,
CA
Cobra Make, Engine:
Posts: 26,618
|
|
Not Ranked
Also, and especially if you have an aluminum intake and heads, you might want to check the torque on the bolts. I had that happen a few years ago, except I caught mine in the front when it was just one small drop falling off the bottom of the block. After checking the thermostat housing and everything, I decided to check the torque of the bolts and about 5 of then had backed off just a little. I torqued them back down and have never seen a drop since then. But I do this on a regular basis now and especially after driving the car hard for a few days. Hope that is is something as simple as that. good luck.
Ron
|
Threaded Mode
