SPF Turn Signals

Marvin · #1 (**permalink**) 10-02-2010, 04:44 AM

Does anyone have a photo of the turn signal stalk?

I called the PO yesterday and he says never had turn signals?

thanks, marvin

Mark IV · #2 (**permalink**) 10-02-2010, 05:10 AM

Quote:

Originally Posted by Marvin

Does anyone have a photo of the turn signal stalk?

http://www.autohausaz.com/vw-auto-pa...placement.html

Note that the SPF uses a connector plug on the end that VW does not. The correct unit is the "1967" one.

Marvin · #3 (**permalink**) 10-03-2010, 04:42 AM

I have that 1967 i guess but it only operates the high beam.

The lever only has two positions it feels like, there is a clear part in tray under dash that looks like a flasher?

PO that bought the car new said never has had signals or at least they did not work?

Guess i need to check further see why the switch seems to only have two positions, also it is on the right of the column, is this correct?

thanks, marvin

Marvin · #4 (**permalink**) 10-06-2010, 02:46 PM

I removed the steering wheel today.

The snap ring that holds the signal stalk was just laying there loose.

Guess I need a drawing, I think someone has had this apart or it was not assembeled correctly.

When I removed the stalk the little contact with spring fell out, I'm not sure the collar that fits inside the stalk and over the steering shaft is oeiented correctly?

And I can understand why the snapring was not in place the left side of stalk collar lacks about 1/32 going down enough to get the ring installed.

Thanks for any advice, marvin

Blas · #5 (**permalink**) 10-07-2010, 04:22 AM

You never sent me that reminder message...Check your email

Marvin · #6 (**permalink**) 10-07-2010, 04:58 AM

Thanks for the reply, will need to wait untill i get time to remove wheel again and i will take photo's.

Not sure if everything is assembeled correctly, or even if all the parts are there.

thanks, marvin