11-19-2009, 08:56 PM
|
 |
CC Member
|
|
|
Join Date: Oct 2003
Location: Golden Isles,
GA
Cobra Make, Engine: Butler Cobra. 350 Chevy Engine, blueprinted, heads cc'd, ported, polished, manifolds matched, big valves, 1.6 roller rockers, TB Injected, mild cam, MSD crank trigger electronic ignition. TKO-600 transmission. XKE Jaguar rear. IFS by Fast Cars
Posts: 558
|
|
Not Ranked
I have had both these tapping guides in my shop for about twenty years and they have paid for themselves time and time again.
Part number 2548A12 Tap & Reamer Aligner, for tight spaces or general use. My unit has a two notches on the bottom so that you can use it on a pipe, round tube or round bar.
Part #2704A12 Manual Tap Driver. I have never snapped a tap using this unit. Holes can also be tapped much faster with it than with a wide handle tap wrench.
http://www.mcmaster.com/#tap-wrenches/=4kumz6
I have seen these at low buck tool suppliers for less $$ I'm sure that the internet will have many sources.
Arthur |
Threaded Mode
