08-29-2009, 02:20 PM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Quote:
Originally Posted by dcdoug
I just fought two of my spinners for 40 min and finally got them off using a 2x4 with a rag wrapped around the end and a mini hand sledge hammer on the 2x4. My rubber mallet was useless. Here's my question - is it OK to put them back on so they are "rubber mallet tight". I will obviously safety wire them as well.
|
Do you really mean a "rubber mallet?" Or do you mean lead mallet? Rubber mallets are next to worthless. You should be using a lead mallet, and of course you MUST apply anti-seize to the thread and mating surfaces. |
Threaded Mode
