Tilton Throwout Bearing mated to McCleod Clutch

[wrench87]

john wha t did you use for a throw out bearing?, i noticed that the internal throw out bearings for the race clutches uses a rounded edge bearing and a chevy bearing is flat?.

[Rosco]

All,

Ended up going with an external slave set-up....

Hopefully an end to the hydraulic mess!

Thanks,

R

[vector1]

Originally Posted by wrench87

john wha t did you use for a throw out bearing?, i noticed that the internal throw out bearings for the race clutches uses a rounded edge bearing and a chevy bearing is flat?.

you want to use a rounded face if you are using a small dia. press. plate because the fingers will roll across the bearing when depressed, a flat bearing is good to go on a larger dia. press. plate where the fingers will not roll onto the outside edge or the bearing movement is smaller, or something like that.