10-23-2008, 06:32 PM
|
|
CC Member
|
|
|
Join Date: Dec 2006
Location: Northwood,
NH
Cobra Make, Engine: Unique
Posts: 91
|
|
Not Ranked
Tilton Throwout Bearing mated to McCleod Clutch
Well, finally determined my McCleod Throw-Out Bearing is junk (leaks).
I am trying to replace with a Tilton Bearing however the measurement is not quite right in terms of mating to the Clutch Fingers. I currently have a McCleod Clutch set-up...
Anyone ever try doing this? Using Shims? Any help or direction is greatly appreciated.... Pictures if possible..
Trying to avoid going the slave cylinder route...
Thanks,
|
Threaded Mode
