03-22-2005, 10:49 PM
|
|
CC Member
|
|
|
Join Date: Sep 1999
Location: Pearland,
TX
Cobra Make, Engine: RUCC 427SC, Small Block Ford
Posts: 35
|
|
Not Ranked
Dreamer
I had the same problem. You need to match the slave and master cylinder size
to get the full stroke. CNC makes a .75
slave it a special order from CNC. They have a few in stock but not listed on the web site or catalog. Just call them at 619-
275-1663. Also if you have a Tremec transmission a company in San Diego called John's Mustang sells a bracket to
mount the slave to the trans. I don't have there phone number but they buy the slaves from CNC so they should have it. This is a pushing slave cylinder not a
pulling type, they might have it in pulling
just ask if you need it. Hope this helps.
|
Threaded Mode
