06-21-2003, 02:08 PM
|
|
CC Member
|
|
|
Join Date: Jan 2002
Location: NorthCentral Pa.,
Posts: 155
|
|
Not Ranked
Input Needed .. 472 Build
Starting with a 1970 DOVE-A Block Bored
.60 over. Zero Deck,Going to be using
D2OE-AB 429 PI Heads. Using Cast CJ
Headers. 850 Holley,Roller rockers, Performer Intake, Shooting for Speed Pro Flat Top Pistons with Eagle Rods. Everything is decided except the friggen cam. I'm shooting for Torque at the low end. THree CAlls to Comp have yielded
three different cam suggestions. I'd like to run 11-1 CR ratio, But I'm getting alot of grief from the builder to lower it to 10-1 I told him I would compromise at 10.5-1. I don't care about fuel costs. Anyhow do any of you have close to the same build and which cam are you using..
Oh. and it's going behind a C-6 with either 3:77 Rear or 4:10..
|
Threaded Mode
