Who makes 3.75” spaced Quick Lifts

[mrmustang]

Originally Posted by renaissance man

Wondering if any of you out there have quick lifts installed on your car that have bolt spacing of 3.75 inches versus the alternative 2.25 inches? I need a set made at 3.75 inches but do not know who makes them? @Cobra Manufactures Group
Here is that thread:
Adapting bumper to Quick Lift

Easiest thing to do is buy a set, have the existing holes welded shut, then redrill the desired pattern.


Bill S.

[patrickt]

Or just cut them out of thick plastic and paint them. No one would know the difference and they're pretty much useless anyway. You sure can't jack your car up with them.

[Snake2998]

Originally Posted by patrickt

Or just cut them out of thick plastic and paint them. No one would know the difference and they're pretty much useless anyway. You sure can't jack your car up with them.

I like that Idea - might even try it for my quick lifts using thick HDPE. Might be less damaging to shins as well!

[renaissance man]

Originally Posted by mrmustang

Easiest thing to do is buy a set, have the existing holes welded shut, then redrill the desired pattern.


Bill S.

Bill, the only problem is the flange on the side does not extend long enough in a straight line to drill a secondary hole or I would probably do that as that is the easiest fix.

[Mark IV]

We have the standard 2.25" quick-jacks available; they are Superformance take-offs, steel power coated black. $100.00 for a set of 4. They have minor blemishes as they have been installed. Pictures available on request. rick@timemachinesauto.com or 716.812.3938

[Mark IV]

We have the standard 2.25" quick-jacks available; they are Superformance take-offs, steel power coated black. $100.00 for a set of 4. They have minor blemishes as they have been installed. Pictures available on request. rick@timemachinesauto.com or 716.812.3938