12-30-2006, 06:17 PM
|
 |
CC Member
|
|
|
Join Date: Jul 2004
Location: Alpharetta,
GA
Cobra Make, Engine: ERA #414 427 s/o w. Shelby Aluminum heads, Edelbrock Performer RPM Intake, Mighty Demon 750, Tremec TKO 600
Posts: 714
|
|
Not Ranked
Here's mine finally...
Made front and rear brackets out of 1" square tube per Steve's instructions. The welding was pretty ugly, but cleaned it up with an angle grinder and painted it.
The picture is of the seat from the back, upside down on a work bench. I also spot welded the bolts on so I could attach it from under the car. Got too frustrating trying to reach the top and bottom at the same time.
 |
Threaded Mode
