12-12-2010, 08:38 PM
|
 |
CC Member
|
|
|
Join Date: Oct 2007
Location: Near Emerald,
Qld
Cobra Make, Engine: Evans kit, 6 litre, 6 speed, Jag F/R,
Posts: 366
|
|
Not Ranked
Quote:
Originally Posted by boxhead
But if you rebore it larger, where are you going to source the larger piston from?
|
Valid point there.
If the toyota one takes your fancy and you only need that little extra have a look for 19 mm toyota cylinders. Nissan has a few 19mm also.
I found the wilwood not the cheapest but OK priced and came with different reservoirs and bits, but, the best bit is the ease of bleeding. All I did was fill the system and let it sit a while, then ran a 6 inch tube from the bleeder on the front of the M/cyl back into its own res. 5 minute job and no crawling around underneath.
__________________
Missed my Cobra budget by thaaaat much.
Ya get that on big jobs.
|
Threaded Mode
