07-25-2013, 05:33 PM
|
 |
CC Member
|
|
|
Join Date: Jul 2010
Location: Perth,
WA
Cobra Make, Engine: FFR Mk4 Roadster, LS3, TR6060, 8 3/4"
Posts: 432
|
|
Not Ranked
Thx guys. Actually as I have it plumbed now it is very similar to what you have Leroy, but my issue is that the top point on the radiator header tanks is just a bit higher than the steam tubes and lower than the cap so I have a small air-pocket there.
The taller cap would help me fill right to the top.
And I had already been looking at that site muzza, it is a good one. I did consider the expansion tank but my main issue is a place to actually put it! And unless I was gunna plumb thru the heater circuit like they say, and instead just run it inline with the top hose (or as a bleed from the top hose) then really it seems to offer no more than a taller rad filler neck.
More thinking required for me!
But thx again.
__________________
Tim
FFR Mk4 Roadster
HSV Clubsport R8
|
1Likes
Threaded Mode
