11-01-2016, 05:47 PM
|
 |
CC Member
|
|
|
Join Date: Jan 2001
Location: Sunbury,
VIC
Cobra Make, Engine: Rat Rod Racer, LS1 & T56
Posts: 5,391
|
|
Not Ranked
I have been looking at making a set using these rebuildable units.
http://www.emfrodends.com/EMF-ROD-EN...-p/ehs0.75.htm
Looking at making some CNC billet front and rear lower control arms for my CR at some point.
I've had requests for arms in the past but they are a fair bit of work to make in 4130 tube. One of my concerns about making them for others and why I have refused is engineering compliance. While I'm confident in my own welding and design I'd worry about supplying the parts to someone else. There are a lot of variables. Once a CNC program is written however it should be straightforward to make consistent accurate arms that I can get an engineer to sign off.
Cheers
__________________
Mike Murphy
Melbourne Australia
Last edited by Aussie Mike; 11-01-2016 at 06:02 PM..
|
8Likes
Threaded Mode
