06-28-2009, 11:43 PM
|
 |
CC Member
|
|
|
Join Date: Apr 2008
Location: Melbourne,
VIC
Cobra Make, Engine: Classic Revival CR 3505, LS1, T56 6 Speed, VE 3.45 LSD Rear, 6 Spot AP Fronts, 4 Spot Wilwood Rears
Posts: 1,121
|
|
Not Ranked
Nearly ready for Painting
Hi All,
Just finished fitting my side pipes (sorry fake), and Roll Bar.
The side pipes I got from Warwick Harrison - I gave him my CR measurements and he made them up. Polished Stainless. Good quality.
I made some custom brackets to suit and all appears ok.
The Roll bar is from Ian at CR. In the new chassis their is a rear mount in the boot. good and bad - Good as you dont need to make a bracket, Bad - you need to make a big hole to get the post through so my hole on the top of the deck is rather large so I need to make a wider bezel for the rear stay.
Now need to work on which method to use to attach Bonnet Scoop. i.e. screws or bonded - open to suggestions here.
Rgds
Gregg
 |
Threaded Mode
