Starting my CR build!

[Roylerumble]

Originally Posted by CFD2DC

Sycraft. Thank you for all of the information. The previous owner had already purchased a mustang 2 front suspension setup with the strut rod delete. It’s all welded in place and ready to go! I also did get the fuel cap pocket with the boxes of stuff for the car. That too is installed and good to go. Planning on setting engine and trans in tomorrow. Just finished the engine build today. I’ve looked at the pedal box and the directions for it in the downloaded manual. That will be one of the next things to tackle. Here are a few pics.

Do you need a copy of the manual? I have a mint one, I could take the spine off, scan it, and send you a copy.....

[CFD2DC]

Originally Posted by Roylerumble

Do you need a copy of the manual? I have a mint one, I could take the spine off, scan it, and send you a copy.....

That would be great! I sent you an e mail through the forum with my info. Thanks!
Jeff

[CFD2DC]

Now that I have the engine and trans in, I can look at pinion and driveline angles. Looks like I’m going to need to raise the pinion up a bit. I used the original upper rear arms that are not adjustable. Do you all run adjustable upper arms? If so, which ones?

Jeff

[rbgray1]

QA1 upper Adjustable!

[CFD2DC]

Thanks for the info. Went with BMR (they were in stock locally). Angles are perfect now! Having driveshaft built next week. Also going to build my own headers. I bought the Speedway DIY set. That will be next week as well!