427 Ring Gear, OUT!

Bobcat · #1 (**permalink**) 09-23-2009, 11:37 AM

Excaliber ... you mentioned there was no good way to run an MSD distributor at 20 to 24 degrees initial with the MSD 18 degree bushing . Almost correct . I`m running 26 degrees initial and a total of 36 degrees by using a 10 degree bushing from FBO in Cottage Grove , Oregon . Call Don there at 541-942-5920 . He makes 10 and 14 degree bushings for the MSD unit . You might also want to check out his website .... 4secondsflat.com .
You may have to open up the slot the bushing slides in some , but I didn`t have too .

Bob

elmariachi · #2 (**permalink**) 09-23-2009, 04:19 PM

Quote:

Originally Posted by Bobcat

Almost correct . I`m running 26 degrees initial and a total of 36 degrees by using a 10 degree bushing from FBO in Cottage Grove , Oregon . Call Don there at 541-942-5920 . He makes 10 and 14 degree bushings for the MSD unit . You might also want to check out his website .... 4secondsflat.com .

Ernie, you seem to buy an old school engine guy, you need to call Don. You guys would hit it off and I'd be curious to hear what you think of his advice on how to properly time these FEs.



FE Forums sponsored by Keith Craft Inc.