Odd Miss

[Detroit Bill]

Originally Posted by Tim7139

You should resistance test the individual plug wires, you'd be surprised how often they break internaly down near the plug boot. Last year I found 3 that tested weak.........cheap fix.
Even though it's a new motor, I would'nt rule it out.

That test is Ohm meter looking for 0?

[Tim7139]

Originally Posted by Detroit Bill

That test is Ohm meter looking for 0?

No, depending on the wires it's something like 50 ohm/foot. Once you pull a couple you will get a baseline and if you have a bad one it will jump right out at you.
At the same time it is a good opportunity to make sure you have a little dielectric grease on the plug ends which will only help the whole equation.
I've found, most often if there's an issue it is right at the plug boot getting bent/forced onto a plug and they fail right at the metal connection.