04-19-2004, 08:59 AM
|
|
Member of the north
|
|
|
Join Date: May 2003
Cobra Make, Engine: A Cobra
Posts: 11,207
|
|
Not Ranked
Just an opinion, but, use a diegrinder and do a smooth cut on the motor mount to allow clearance. Paint the bare metal. If the headers have nothing other than paint on them, you can dimple the area A LITTLE.
Set the timing at 4 - 12 degrees BTDC to start. ( 4 BTDC is my personal choice just in case )
Plugs are a fit and try item for me. Check with the book and go from there.
Just a thought.
__________________
I'm a writer, feed the artist and buy a book.
|