Need help diagnosing a clutch/tranny problem

[csx4017]

Apparently I need to get my fingers checked.......I will try and get my hand up into that area. The frame cross member aft of the diffy is always fun to work around. Thanks

[patrickt]

Originally Posted by csx4017

Apparently I need to get my fingers checked.......I will try and get my hand up into that area. The frame cross member aft of the diffy is always fun to work around. Thanks

There is a much easier way. New Cool Tool - DeWalt DC410 Inspection Camera - Quick Review with Pics and Video

[dcdoug]

Originally Posted by patrickt

There is a much easier way. New Cool Tool - DeWalt DC410 Inspection Camera - Quick Review with Pics and Video

I provided a unit just like that to Cobra Inc awhile back.....least I could do since my car's been there since October....

[patrickt]

Originally Posted by dcdoug

I provided a unit just like that to Cobra Inc awhile back.....least I could do since my car's been there since October....

Where are you getting your stubs from, and what's the guesstimated delivery time?

[dcdoug]

Originally Posted by patrickt

Where are you getting your stubs from, and what's the guesstimated delivery time?

I sent my stubs off to Roger Bolick in Austin (Exact cobra) on Nick Acton's recommendation. Roger has done a lot of cobra diff repairs and has a race shop in TX build the stubs for him. He's collaborated with them to build the highest strength stubs for the cobra application. Roger measured and tested my stubs to be sure they would fit exactly as compared to his (since there are minor difference in the "same" stubs and it has caused problems before). I hope to get them in the next week or so.

By the way, D-Cel has agreed to analyze the steel in my original stubs and we will report back why they failed.