New Project - Pusher Fans

[FredG]

Pusher fan project is completed and works great. Fans are more powerful than expected and work independently from puller with a dash mounted toggle. Parts used in project are listed in above posts.

[spdbrake]

Great job Fred! Do you have the PN of the bathroom partition bracket? I know it most likely a standard spec but just to make sure I don't order a one-off.

[FredG]

The fan support is 3/4 x 3/4. I ordered two different size brackets from two different companies. One is 3/4 wide and the other is 1 inch wide. I went with the bigger one and used some stainless steel washers to take up the space. I found this easier because it's difficult to get the brackets perfectly parallel. Also, the 1 inch bracket is longer and beefier. The bottom one is one I went with.

https://www.allpartitions.com/urtwoearheav.html




https://www.robertbrooke.com/chrome-...2-x-3-1-2.html I used this one. Picture on bottom

[NoVA Cobra]

Originally Posted by FredG

Pusher fan project is completed and works great. Fans are more powerful than expected and work independently from puller with a dash mounted toggle. Parts used in project are listed in above posts.

Thanks, Fred. Looks nice. I see how the brackets mount to the bar, but I'm curious how the brackets are mounted to the car. I just have a lot of fiberglass inside the cowl and around the radiator. How did you attach the brackets to the car? Are you drilling holes and mounting to fiberglass directly?

[FredG]

Yes. I drilled through the fiberglass and mounted with stainless bolts and stainless nylon locking nuts. There are quick connect electrical fittings also. It's easy to take the whole thing out.

Originally Posted by NoVA Cobra

Thanks, Fred. Looks nice. I see how the brackets mount to the bar, but I'm curious how the brackets are mounted to the car. I just have a lot of fiberglass inside the cowl and around the radiator. How did you attach the brackets to the car? Are you drilling holes and mounting to fiberglass directly?