HTM111 - Gonna need some work

[1985 CCX]

Ok, gonna share the process, hope to be driving again next summer.
Body on order, hoping to deliver in Spring “23”
Disassembly under way ......

Once the body is off I’ll work on the frame and hardware upgrades.

[1795]

Good luck Jeff! Maybe you will find all that you need underneath the Christmas tree

[Maxjeep]

Originally Posted by 1985 CCX

Ok, gonna share the process, hope to be driving again next summer.
Body on order, hoping to deliver in Spring “23”
Disassembly under way ......

Once the body is off I’ll work on the frame and hardware upgrades.

Old post but I have to ask. How did you order a body? I sure could use the front half. I tried to PM but I don’t think I have been here or had enough posts to get those privileges yet. I also read that you have fabed frame brackets. I need a few. You have a cool project going on!
You are better off fixing your own stuff. Unless you have a blank check it’s hard to get good results.

[1985 CCX]

Max?

Best to call or email.
Basically, you will be limited to CSX-Glass or HTM (probably close) as some bodies are thicker due to frames and other the wrong shape.

I tried SAI and it was way to $$$, Gary even said Alloy.
HTM is gone so ..... Later did find a rear clip but alloy deposits were sent and I did not want to be a schmuck.
I ordered a alloy rear clip, doors, hood and boot. That too is a long process in the months and also not cheap. I'll start another thread when that process starts... Alloy in process...

BTW the SPF body will no doubt be difficult at best to fit, my guess thick and shaped differently.

These cars are expensive for a reason, costly and require a fair bit of drive and patience to complete. You can do it, we all can just depends upon your persistance.

Just understand you will have more $ into this than you plan for.

My contract below....