05-27-2005, 05:45 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Sep 2000
Location: Holderness, NH, US of A,
NH
Cobra Make, Engine: CSX 4772 old iron FE
Posts: 5,499
|
|
Not Ranked
Hi Bob, the CR prints give a dimension to the back of the block which is likely what you are after if your using the same tranny. The motor mounts on your motor I believe through bolt front to back with a saddle where the FE's use a stud that goes down through a plate. I'll get that number on the back of the block if I can figure where everything is between shop, computer, book shelf and work........?????
|
Threaded Mode
