08-31-2013, 10:13 PM
|
|
CC Member
|
|
|
Join Date: Apr 1999
Location: Waco, TX,
TX
Cobra Make, Engine: ERA #766, FE V8, Toploader
Posts: 257
|
|
Not Ranked
Dan, I just noticed the part of your message about the engine tilter--I did not use one. My engine came with a lifting plate bolted to the intake manifold. It had three large holes in the vertical lifting portion. We started off using the forward hole thinking that a lot of tilt would be necessary, but it was too much! We ultimately used the center hole instead with no problems and with good results.
|
23Likes
Threaded Mode
