OK...finally finished putting UCOAT-IT on the garage floor and was able to get back to the Cobra and have a look at this electrical issue...GOOD NEWS>...I located the issue.
The issue is at the large red connector on the harness (with the yellow and red wires). I started it up today after reseating all connections and as it was running I lifted the harness a little at this connection. The engine immediately cut out...as I let go...the engine would pick up and run again. I did this a few times so I am sure the issue is at this connector.
Any suggestions on what to do about it?
__________________
"There are 10 types of people out there....the ones that understand binary and the zeros that don't."