06-18-2003, 07:09 AM
|
 |
CC Member
|
|
|
Join Date: May 2001
Location: California,
Ca
Cobra Make, Engine: NAF 289 Slabside Early Comp Car with 289 Webers and all the goodies. Cancelling the efforts of several Priuses
Posts: 6,592
|
|
Not Ranked
You will need to remove the "Pinion Support" from the housing because the preload on the bearings will have to be reset after the seal is replaced. If you have the option choose the solid machined spacer rather than the "crush sleeve" used in OEM applications. If you have not done this before it is best referred to someone that has. It takes a certain "touch".
Rick
__________________
Rick
As you slide down the Banister of Life, may the splinters never be pointing the wrong way 
|
Threaded Mode
