09-10-2020, 11:38 PM
|
|
CC Member
|
|
|
Join Date: Oct 2003
Location: Spokane,
WA
Cobra Make, Engine: Shell Valley, 351W
Posts: 183
|
|
Not Ranked
Hi Martin,
The cross bar that I have is made for a 1 1/2" OD roll bar. The clamps are 1 5/8" ID and 2" OD. the rubber insert is 1/16" thick which makes it fit a 1 1/2" bar. I think it would fit a 1 5/8" OD bar without the rubber insert installed if one chose to do that and was not concerned with scratches, or maybe a single layer of electrical tape. I do have one left.
Sydney
|
Threaded Mode
