01-17-2007, 11:48 PM
|
 |
CC Member
|
|
|
Join Date: Oct 2003
Location: Golden Isles,
GA
Cobra Make, Engine: Butler Cobra. 350 Chevy Engine, blueprinted, heads cc'd, ported, polished, manifolds matched, big valves, 1.6 roller rockers, TB Injected, mild cam, MSD crank trigger electronic ignition. TKO-600 transmission. XKE Jaguar rear. IFS by Fast Cars
Posts: 558
|
|
Not Ranked
Well guys, after much consideration, I'm taking the plunge. I've started building a level table for my Butler. I love everything about my car, except the IFS, so I'm going to give it a new one. I hope it will be one deserving of the car.
I do not want to cut-off any parts from the chassis. I want it to be a bolt-on application and able to put the MGB back on. I may do that sometime in the future for yucks, as I have a completely rebuilt MGB ready to go.
After the table is done, I will put the car on it, take all measurements: At the correct height. then proceed to the next step. I will keep you posted with photos and comments.
Regards,
Arthur
Last edited by lal Naja; 01-17-2007 at 11:50 PM..
|
Threaded Mode
