Superformance MKII, Riverside Racer 289 FIA vintage race car

[1795]

Originally Posted by Blas

Just to keep post accurate for future racers, one can buy other size slip yokes for T10`s, TopLoaders, etc. Below is a link.

1350 SERIES - TRANSMISSION SLIP YOKE - FORD C4, AOD, MOST TOPLOADER 3&4spd, TREMEC T-5 - 28 SPLINE FORD SLIP YOKE - SKU#(s) 3503-281 - Fort Wayne Clutch & Driveline

Blas,

Thanks. I saw a similar site but was not happy with the idea of it being a 27/28 spline shaft with a dead spot. It might be fine, but just worried me a little. Wanted something that was made specifically for a 28 spline.

Jim

[Blas]

Additional sources:

Mark Williams Enterprises 1350 Series Chrome Moly Slip Yoke for Tremec Manual Transmissions with 28 spline output 39022


SONNAX T3-3-8251HP FORGED Chromoly Slip Yoke for TREMEC transmissions with 28 spline output 1350 series

[1795]

Blas,

Thanks. If I need to upgrade in the future, I will.

Jim

[1795]

No pictures today, will have some later tomorrow or Monday. Spent yesterday and today installing the MSD system, leveling the transmission tail with the differential and planning out the transmission support. The car comes with a transmission support that is set up for a Tremec and the support is about 3 inches aft of the transmission support on the tail housing for the Toploader. I have to make a bracket that will bolt to the existing transmission support and then drop down an inch and go forward 3 inches to allow it to be bolted to the poly transmission support bracket on the Toploader.

Also have been planning out the install for the race harness, wired in the kill switch and will be working on the fire system as well. Things are coming together, but there is no way that I will be ready for the July Sprints at Watkins Glen next Friday, so I will be running the MGB there to get some more track time and will have the car ready to race at the US Vintage Grand Prix at Watkins Glen September 7.

Jim